P124A BMW Fault Code

Description:

Catalytic converters must be warm before they can work properly. On a cold start the PCM provides a rich mixture to keep the cold engine running.
All that extra fuel goes into the catalytic converter. But the exhaust isn't very hot, because, ah, the engine is pretty cold. GM has employed several strategies to fire up the catalytic converter quicker and reduce cold start emissions. One way is to use a secondary air pump that pumps outside air directly into the catalytic converter.

P124A Code Symptoms :

If your vehicle failed a P124A test and the P124A Check Engine Light is NOT on, chances are you have a problem with the OBDII system, a burned out MIL lamp, or a faulty catalytic converter. The converter is essentially an afterburner that cleans up the exhaust after it exits the engine. The OBDII system uses P124A a ownstream oxygen sensor to monitor the efficiency of the converter, and it should detect a drop in converter efficiency if the converter has been contaminated or is failing (ignition misfiring, leaky exhaust valves, and oil burning can all damage the converter). What you want to look : Any conditions that might cause ignition misfire, an overly rich or lean fuel condition, or loss of compression.

Diagnosis And Repairing P124A

P124A OBD2 may also be triggered by faults earlier down the line. For example, a dirty MAF sensor might be causing the car to overcompensate in its fuel-trim adjustments. As a result, oxygen sensors are likely to report fuel mixture problems.

How to fix P124A code ?

• Air fuel ratio (A/F) Sensor 1 Bank 1 harness is open or shorted
• Camshaft advance mechanism binding (VCT unit)
• Incorrect fuel pressure
• Faulty variable valve timing (VVT)

In most cases, the TCM is integrated into a single housing with the BMW PCM. Nevertheless, the section of the module which controls (automatic) transmission function may be powered up separately.

In any case, the TCM is typically powered using switched (only present with the ignition switch in the ON, start, or run position) voltage. This circuit is normally equipped with a fuse, fusible link, and/or a relay. Frequently, the PCM and TCM are powered using the same relay albeit by separate circuits. Access to a reliable vehicle information source will yield necessary details of the TCM power circuit for the specific vehicle in question.